Honda Door Lock Actuator Screws Stuck

Using a screwdriver test that the locking mechanism works by locking the latch then checking if the door latch releases using the outer handle lever.

Honda door lock actuator screws stuck.

2007 honda cr v door lock actuator repair. Unclip and remove the inside door handle rod can t remember if i did this before or after unscrewing the locking mechanism. Unclip the broken actuator from the locking assembly. Just unhook and slide through the holes on the metal.

Remove this screw and unhook the tabs holding the black plastic housing for the actuator. The lock actuator is behind this screw. Car door lock actuators are designed to lock and unlock a door without the effort of pulling on a cable and rod. Average repair cost is 610 at 84 500 miles.

The 2010 honda cr v has 4 problems reported for door lock actuators failed. Make sure the open link tab fits into the open link slot. Observe the plastic tab above and beneath this screw. A rod connects the actuator to the latch and another rod connects the latch to the knob that sticks up out of the top of the door.

Remove the single screw in the middle of the gold plate taking care to note the position orientation of the small locking lever. If you are having problems with your door locks this is the video for you make sure to watch until then. In some cars the door lock actuator is positioned below the latch. Install the lock subassembly onto the new door lock actuator using the new screws from the kit p n 72116 swa a01 and p n 72116 swa 003.