Wiggle the lock toggle or thumb button as you apply the graphite to work it into the mechanism.
House door lock won t turn.
This is all to say that when your door knob turns but won t open the issue is with you handle not properly interacting with the spring in the latch.
In the resting state of the lock the spring is extended.
Use the chisel to remove the door stop.
Lubricate knob locks with graphite.
A key that doesn t turn in the lock could have several causes.
Pry up on it until it comes loose and remove it.
Door lock doesn t latch properly when a door latch doesn t click into position it usually means the latch and the strike plate are out of alignment.
If it won t lock open the door.
Spray the lock with lubricant to remove dirt and dust.
When the door knob is locked the handle will not turn which keeps the latch from retracting.
Key won t turn in lock i couldn t get my mail so i tried something whilst the camera was rolling and it was almost a miracle result.
There are a number of issues that you might have with locking your door.
Slide the key in the lock and tap lightly on the key to lubricate the inside of the lock.
Tap the end of a chisel under the door stop on the striker side of the jamb.
It should have at least a one inch throw and on the strike side there should be a security plate with screws at least three inches long.
Don t use a wet.
The best lock is a dead bolt that s properly installed.
You may be able to take care of the problem yourself or you may need to call a locksmith for help.
Repairs range from making minor latch adjustments to repositioning the door.
If you re having problems trying to lock your door your key is stuck or your key is hard to turn in the lock we have the expertise to help.
After a long day at work the last thing you want is to come home put your key in the lock and find that it won t turn.
Key won t turn in lock i couldn t.
Here are some common ones and their likely causes below.
Spray the door key with a graphite based lubricant.
Tighten the hinge screws and then try adjusting the strike plate by loosening its screws and shifting it slightly.
Squirt a small amount of graphite into the seam around the lock.
