To set a cuckoo clock you ll need to hang the clock on a wall start it then turn the minute hand to the right time.
How do i set my pendulum wall clock.
Step 2 open the access panel door to the pendulum and bring it to a stop.
To set the clock in beat reposition the crutch of the pendulum.
Setting the beat of the pendulum clock if the beat is irregular like.
This can be done by either try leveling again from left to right by moving the clock very slightly from the bottom until you hear the most even tick tock.
The centre motion of the crutch must be in the centre of the clock.
Using a gentle hand bend the crutch in the middle of its length to the desired position.
As the hand forwards through time chimes will sound but just keep moving the hand to the correct time.
Pendulum clocks with a time adjustment nut grandfather clocks most wall clocks german mantel clocks shelf clocks etc the adjustment nut is a large nut at the bottom of the pendulum just below the large disk or weight called the bob.
If it is a few minutes before or after the hour when the clock strikes the minute hand requires an adjustment.
Turn the smaller minute hand counterclockwise to number six.
1 adjustment nut on the pendulum if your clock has a small nut on the bottom or another place on of the pendulum then use this method.
Then wind the clock by gently pulling the chain without a weight on it towards the floor.
2 check your clock against accurate timepiece or computer.
Note the clock position in which the pendulum swings freely.
There are two methods of adjusting the time regulation on your pendulum clock.
Adjust your pendulum clock to the correct time and then set the clock on a level surface and check that it is wound appropriately or not.
Place a wedge underneath the clock in the place needed to maintain this angle.
Then you need to swing the ball to the left for it to start.
Start with the clock hanging vertically on the wall.
Setting the time on a strike pendulum clock may be all that is needed to synchronize the chimes.
To change between am and pm pass 12 o clock with the clock hand.
Gently nudge the pendulum to one side to the clock starts ticking.
Continue turning the small hand in the same direction if there is no strike.
To slow down the clock loosen the adjustment nut turn it toward your left.
Make certain the time is correctly set to am or pm.
Listen for the strike of the clock.
Set the clock to the correct time by turning the hand clockwise.
Check the position of the minute hand of the clock when the top of the hour strike occurs.
If a wedge alone will not hold the seth thomas grandfather clock in the proper position try lifting the clock slightly up against the wall.
The pendulum crutch is a small piece of wire that goes through the pendulum arm.