How Do I Tightn The Freezer Door Handle Kitchenaid

Find replacement handles and medallions for your kitchenaid bottom mount top mount french door or side by side refrigerator.

How do i tightn the freezer door handle kitchenaid.

Most handles require a 3 32 or 1 8 allen wrench to tighten. Get an allen wrench usually 3 32 or 1 8 to use to tighten the screw on the freezer door. Most freezer door handle allen screw sizes are 3 32 or 1 8 you may also need a 10 mm socket and ratchet next open the freezer door side that has the loose handle or damaged handle. Slip the blade of a flathead screwdriver beneath the hinge cover at the top of your kitchenaid superba top mount refrigerator.

When the screws feel tight tighten them an additional quarter turn using the hex key. The handles are installed by the owner or installer as directed in the installation instructions. Twist the screwdriver to pry the cover off the hinge. If the handle has allen screws you need to remove these and set the handle off tighten the support and put the handle back on if no allens then get hold of the handle and give a jerk to the left and set off tighten the support put handle back on and pull to the right appliance tech larry home appliance tech.

How to tighten the handles. To make the refrigerator less cold adjust the control to the next lower setting. Tighten the set screws at each end of the handles. Repeat this process until the desired temperature is reached.

Your reference to the set screw is correct. If you need to adjust the temperature wait at least 24 hours between adjustments and then recheck the temperature. How to fix a loose freezer door drawer handle. Some bottom freezer handles are not factory installed.

The handle is not properly installed without this extra tightening. Once both setscrews have been partially tightened as instructed in the installation instructions fully tighten both setscrews using the 1 8 hex key provided. You will need to tighten that screw to snug up the handle on the button that is attached to the door the set screw should be just a standard allen wrench design which is a too that looks like an l shape woth a hexagon shaped cross section.