Insert a 2 1 8 inch hole saw into your drill and position the pilot bit on the mark you made on the face of the door.
How do you cut circle for door handle.
Section 142 3 labor code.
This ensures you don t splinter the wood on the face of the door as you blast through drilling from just one side.
Place the edge of a sharp chisel into any of the mortise outline grooves.
Measure 40 inches up from the bottom edge of the door.
Countersink the mounting screw holes so the screw heads won t tear up your workpiece.
Don t just drill from one side.
You want to keep the drill level and square.
Apply firm pressure as you drill the hole into the door making sure the hole saw is flat and not angled as it goes through the door.
With the large hole cut it s now time to drill the small 1 inch hole in the edge of the door.
This is very difficult to do.
A latch or other fastening device on a door shall be provided with a knob handle panic bar or other simple type of releasing device the method of operation of which is obvious.
Grab your drill and insert the 2 hole saw into the drill.
Screw the trammel to the workpiece centering it on the circle you want to cut out.
Hole in the center of the router end to clear the router bit.
Place a strip of masking tape on the door with the bottom edge of the tape marking the 40 inches.
Authority and reference cited.
Title 24 part 2 section 2 3303 c note.
Cut out the trammel and drill a 1 1 2 in.
With any luck a metal door custom made to fit your entryway will arrive with a hole already furnished for the lockset the correct term for a.
Locate the latch face plate screws with your door knob.
So take the time to mark and cut carefully.
Finish drilling the hole from that side of the door.
Holding the drill steady to prevent wobbling drill through the door until the tip of the pilot bit emerges from the other side of the door.
2 measure in 1 1 2 inches along the bottom.
Whether you re installing a lock plate also called a strike plate for a deadbolt lock or a standard lockset you first must install the lock or lockset onto the door following the manufacturer s instructions.
How to cut a hole for a door knob in a metal door.
You want to drill part way into one side of the door stop and then start to drill from the other side.
Section 142 3 labor code.
And section 18943 c.
Attach the router to the trammel with the base plate screws.
