Watch this step by step video guide from bunnings warehouse and learn how to make sure the handles.
How do you install a door handle.
Installing a lever door handle quickly and easily.
It should feel slightly snug when the two parts join.
Installation instructions start by removing your old storm door handle.
Install the latch determine whether you want to use a flat rectangular faceplate or a round drive in faceplate.
Use the allen key provided in the door handle kit to lock and secure the faceplate.
Install both knobs by sliding the spindle through the slot in the latch.
Remove the two screws holding the strike plate in place on the door jamb and install the new one in the same position.
Place the exterior handle on the door by inserting the spindle or axle on the handle through the latch cylinder at 90 degrees.
Repeat this process to attach the other faceplate.
Trace the handle s faceplate with a pencil.
Place the chisel at a 45 angle and begin to chisel the.
First take out the old door handle assembly by unscrewing the two screws that secure the.
Slide the faceplate over the door handle and snap it into place.
Place the corresponding doorknob or lever on the interior side of the door fitting the two parts together.
Set the latch of the door handle into its hole and make distinct marks to.
If you re installing a backplate and your current handle doesn t have a backplate you may need to drill a.
Setting the door handle 1.
Screw on the handles.
Install the inside.
Installing a door handle is a relatively easy diy project.
Install the outside handle if your new door handle attaches to the door at a point below the lower borehole.
With the latch assembly in place slide the door handle with the attached cylinder into place.
In this kit the hole for the allen key is at the bottom of the faceplate.
Step 2 remove latch mechanism.
It must line up with the holes in the latch assembly to function properly.
Chisel out the faceplate outline with a chisel and hammer.
Step by step directions step 1.
Take out two screws setting in the door edge and slide latch mechanism out.
Align the two long screws from the inside knob into the cylinders on the exterior door knob and tighten the screws.
