A good rule of thumb is to center the hardware horizontally on the stile.
How high should the center of door handle be.
Most people place the hardware between 2 and 4 inches from the bottom edge of the door.
Locate the lower right or left hand corner of the cabinet and measure up at least 2 inches.
That means it attaches roughly in the middle of the stile.
According to tim carter of ask the builder the proper height for drawer pulls and handles is approximately 2 to 3 inches from the lowest corner of the door.
Acceptable types of handles include u shaped push type and lever type handles or mechanisms.
The international building code has established doorknob height between 34 and 48 inches above a finished floor.
This is generally the easiest most standard ones are placed around 36 off the floor level with all the other knobs in the room.
These federal regulations for door handle height state that door handles must be at least 48 inches from the floor level.
They must also be easy to operate with one hand without a tight grasp or a twisting of the wrist.
The best method is to actually use a laser level as not all floors all level and i have seen rooms where you can see the slope.
The exception to this is when the height of a drawer front is greater than 12 in this case we recommend placing the hardware towards the top of the drawer front.
256mm center to center and about 10 long bar pull.
Move in a minimum of 1 inch and mark the space.
Those are what i recommend in the diagram.
Door handles pulls latches locks and other operating devices shall be installed 34 inches 864 mm minimum and 48 inches 1219 mm maximum above the finished floor.
So you may want to step up in size.
Deadbolts are typically placed above the door handle anywhere from 48 to 70 inches from the ground.
Installers typically drill the hole centered 36 inches above the floor if not specifically instructed to do so differently.
This may change for taller doors but generally not.
This makes it much easier to open.
Exceptions to the rule include doors that provide egress into swimming pools or other water features.
Locks used only for security purposes and not used for normal operation are permitted at any height.
