How Ti Mount A Pedastal Sink To Wall

Metal brackets screwed into the wall serve as a durable and glue free way to mount your pedestal sink bowl.

How ti mount a pedastal sink to wall.

Install the bracket with the lag bolts. Hang the basin on the wall bracket and then install the mounting screws to hold the sink to the bracket and wall. When installed properly brackets are just as sturdy as glue sometimes more so. The lumber is secured to the wall studs and covered with a drywall patch.

Then make a mark 10 inches from the wall accounting for the baseboard. For drilling into concrete use a hammer drill and a concrete bit. Check the level of the sink. Set the sink on top of the pedestal then slide the sink close.

The pedestal sink must be mounted to the floor for stability. If you are not comfortable gluing your sink bowl directly to the wall you have an alternative in the form of metal brackets. Carefully move the sink and pedestal back against the wall. Be sure not to over tighten.

When you push the pedestal sink against the wall you can screw it to the lumber behind the drywall. This distance for this mark may vary with different sinks center the pedestal on the mark and set the sink tight against the wall. Make a mark about ten inches from that wall with consideration of the baseboard. It never hurts to double or triple check.

Then temporarily mount the pedestal to the wall using washers and nuts. It doesn t have to be super tight at this point. If you don t have a mounting bracket line up the basin s mounting holes with the hanger bolts you installed earlier. Then you have to center the pedestal on that mark before setting the sink tightly against the wall.

Mark the anchor holes of the sink on the wall while doing the hole of the pedestal on the floor. Installing the sink the pedestal base is set into place and aligned with the mounting holes drilled in the floor when applicable. Then you can drill the holes by putting aside the pedestal stand and sink aside first. The technique for doing this will vary depending on the type of floor.

Mount the sink basin on the mounting bracket. Test fit the pedestal mark its location and then move it safely out of the way. Place the sink on the pedestal and double double check for level yes i meant to say that. Thus install the hanger bolts on the wall by leaving an inch extension from the wall.

Mark the centerline of the sink on the wall and floor. In addition check the pedestal is level. If the sink doesn t have a mounting bracket install it directly to the wall with the fasteners provided. Although it isn t the preferred way of securing the sink to the wall you can use adhesive caulking as well.