How To Adjust Glass Shower Door Hinges

Or you could be looking at a more intense job of removing doors and adjusting rails or hinges to give you a better fit.

How to adjust glass shower door hinges.

You ll commonly find hinged glass doors in bathroom showers with the hinges drilled directly into the glass or held in place with pressure alone. A door hinge that has come loose may cause the door to drag at the bottom causing damage to the door. Since they do not have a frame the track or hinges must be attached directly to the glass or at least appear to be. Open the door slightly and place wedges under it so the weight is supported.

Step 2 adjust the door. Frameless shower doors consist of tempered glass with two or three hinges at one side. Actually the hardware usually clamps the door when you tighten the screws and a rubber gasket between the hardware and the door prevents damage. Remove the door and clean all of the screws.

While adjusting you will likely need a partner s help to prevent the glass door from falling to. Damage to the door and frame can result as well as water damage to the floor. Frameless glass shower doors can hang from an overhead track or from side hinges. To avoid sagging shower doors tighten the door screws regularly and avoid slamming the door.

Adjusting shower doors is a fairly easy task to take on. Fix any loose screws on the hinge attached to the walls and then unscrew the other side from the door. You can move the upper rollers so that the door is swinging a little higher in the gap and you can also fix the hinge to the shower door a little further down so that it flows freely. Replace or adjust the rollers in the same way.

If you notice leaks at the sides or bottom of the door there s a good chance the door is out of alignment. They ride along a slanted adjustment slot that will raise and or lower the wheel. When it comes to learning how to adjust shower doors it can be a task that is as easy as cleaning and lubricating the rails or hinges. To fix a sagging shower door all you ll need is a screwdriver hammer and scrap wood.