How To Attach Christmas Lights To A Masonry Wall

4 press the socket to the brick for about 20 seconds.

How to attach christmas lights to a masonry wall.

To use a clip just snap it over the brick vertically in the location where you want it to hold the light string. Start at one end and apply hot glue along the side of the base of the light then press it firmly against the brick. They can damage walls and interior surfaces plus. Apply firm and steady pressure to your drill making sure you re at right angles to the wall s surface.

Masonry fasteners and anchors are permanently placed into concrete brick and stucco but are complete overkill for hanging christmas lights. Clean the bricks with a rag brush or broom to get all dirt and debris off the surface of the bricks wet a sponge and wipe across the surface of the brick. Stick a small adhesive decorating clip to the walls in each place you want to attach a strand of lights. Start at one end and apply hot glue along the side of the base of the light then press it firmly against the brick.

If you prefer having the lights stick out from the wall instead place a dot of glue under the base of each socket. Hold it for about 10 seconds which should be enough time for the glue to cool and the light to adhere to the brick surface. Slide the coated wire portion of the light strand through a hook in the clip to. Lay out your string of lights to ensure you have enough length to work with.

You ll need yellow wall plugs a drill with 5mm masonry bit and a dustpan brush set the drill to the hammer setting. The bulbs will be perpendicular to the wall once you finish hanging them. To secure a vertical stretch of lights going straight up or down the wall face the clips in.