To attach it lay the door frame on its side with the hinge side facing up.
How to attach hinge side shim storm door.
Above the top of the door with a square.
If it is you will need to replace the shim and add more screws.
If the door isn t aligned you will need a thicker shim.
Position hinge rail along hinge side edge of door frame so bottom hole of the 2nd hinge up from the bottom lines up with bottom.
Confirm the door swing direction and fasten the hinge side z bar to the correct side if necessary.
If the molding moves secure it with extra nails photo 1.
Slide the weatherstripping aside and cut the z bar with a hacksaw.
Place it in the opening tight against the rain cap.
Start by adding a couple of nails near the top of the wood trim.
It might also help to install a shim to reduce the wear and tear and fix the sag.
Watch the hinge side of the door frame.
Before you grab your tools partly open the door from the outside and push the door up and down.
Then add nails farther down if necessary.
Tighten the existing screws in the frame using a screwdriver.
Fixing an uneven storm door frame may be as easy as installing shims behind the door hinges.
Cut hinge side z bar as in step 3.
The hinge side z bar is an aluminum component which attaches to the hinge side of the storm door.
The storm door frame mounts inside the wooden door frame opening on your home.
Screw everything back in place then check the alignment by opening and closing the door.
Lay on door carton.
Your shim can be derived from a piece of wood or even cardboard whatever you have handy.
As your house settles you may need to adjust the storm door frame.
These will likely be located all around the door.
To do this unscrew the bottom hinge and clean off any dirt or debris.
Identify the top of the hinge rail d.
Then place a strip of wooden shim or cardboard by the hinge.
Place latch side edge of door frame on the ground.
When the wood expands and contracts it can cause the frame to become uneven.
Last check the door s operation and alignment by opening and closing it.
Adjust it so there s a inch gap between the bar and the door s.
Be kind to your storm doors.
Place your shim by the hinge and screw all of the components back into place.
Remove the 2nd and 3rd screw from the top on the hinge side edge of door frame.
Take the hinge side z bar and line it up along the side of the door.
