How To Attach Insulation Panels To A Garage Door

Use clean water and a rag to remove.

How to attach insulation panels to a garage door.

Alternatively use two layers. Push insulation flat against door and feel for retention clips. Measure the height and width of the panel and mark the center of each panel with a pencil or marker. Repeat this step until you have cut enough insulation to cover the entire door.

The instructions tell you how to measure out everything and mark it but let s just say you measure to find the center of each panel on your door then you half it again. Slice inch slits through the insulation above the retention clips and attach the front of the retention clips to the back pieces to secure the insulation panels. Use 1 1 2 inch thick insulation for doors with metal framing and 2 inch thick material for doors without it. Attach two retainer clips for large panels.

Cut a sheet of rigid foam insulation to fit each section. Use a marker to place an x in each place so you can come back quickly and just attach all of the adhesive. Fit the cut insulation into the panel with the vinyl side facing into the garage. Adhere insulation to garage door open your adhesive and start adhering your cut insulation to the door.

Panel sizes may differ along the door so measure each one as you go rather than pre cutting all the panels based on one measurement. That way you will end up with two spots on each panel. Repeat until all the panels are insulated. Press the insulation into place if you have panel railings.

Many garage doors will have metal railings 1 or 2 inches 2 5 or 5 1 cm deep that can be used to hold the insulation in place. Repeat this process for each panel. Cut foam insulation to size now that you know the dimensions for each panel on your garage door cut the foam insulation to size. Prepare the inside face of a one piece metal or wood door where adhesive is needed to attach the foam insulation.

Once the insulation is cut to size you push the panes over the pins and attach the pin cover. Remove dust and cobwebs with a utility brush. The pins secure in place to a clean and dry door panel. Apply double stick adhesive at the mark and attach the retainer clip.

If needed you can use a little bit of masking or duct tape to help you hold each foam panel in place as the glue dries. Instead of adhesives you will use a puncture pin system to mount the panels to your door.